智能过欠压过电流自动保护器
点击次数:525
产品详情

名称:双显过欠压保护器 adjustable voltage protector




■ 用途 Purpose

多功能自复式双显保护器集过压保护,欠压保护,过流保护与一体的综合智能保 护器,当线路中出现过压,欠压及过流故障时,本产品能瞬间切断电路,避免电气设备造成不必要的损坏。当电路恢复正常时保护器能自动恢复电路使用电气设备正常工 作,本产品的过压值,欠压值,过流值,电路恢复时间值及过流保护复位时间值值均 可自行设定,可根据当地实际情况及电气使用条件进行相应参数调整。
Multifunctional self resetting double display protector is a comprehensive intelligent protector integrating overvoltage protection, undervoltage protection and overcurrent protection. When overvoltage, undervoltage and overcurrent faults occur in the line, this product can instantly cut off the circuit to avoid unnecessary damage to electrical equipment. When the circuit returns to normal, the protector can automatically restore the normal operation of the electrical equipment used in the circuit. The overvoltage value, undervoltage value, overcurrent value, circuit recovery time value and overcurrent protection reset time value of this product can be set by themselves, and the corresponding parameters can be adjusted according to the local actual situation and electrical conditions.


■ 产品特点 Product features

产品完全符合企业标准生产的单相自复式重合闸保护器;

当线路发生过压,欠压及过流故障时本产品自动切断线路,当线路电压或电流恢复 正常时本产品按用户设定的延时时间后自动恢复正常供电,线路出现瞬间或暂态过压时保护器不产生误动作。

线路因某种因素造成电压不稳或突然断电再来电状态时本产品不马上接通电源,此延时时间由用户自行按当地情况而设置。

线路电压在最高时不应高与330VAC以防止产品自身由于电源电压过高而损坏,如 有特定场合需要高电源与厂家联系。

The product fully conforms to the enterprise standard and produces single-phase self resetting reclosing protector;
When the line has overvoltage, undervoltage and overcurrent faults, the product will automatically cut off the line. When the line voltage or current returns to normal, the product will automatically restore the normal power supply according to the delay time set by the user. When the line has instantaneous or transient overvoltage, the protector will not misoperate.
When the voltage of the line is unstable or suddenly powered off and then called due to some factor, the product will not be powered on immediately. This delay time is set by the user according to the local situation.
The line voltage should not be higher than 330vac at the maximum to prevent the product from being damaged due to the high power supply voltage. If there is a need for high power supply in specific occasions, contact the manufacturer.


■ 正常使用条件 Normal service conditions

环境温度不超过+50度和不低于-10度。

安装地点海拔高度不超过2000米

湿度:不大于60%

污染等级3

The ambient temperature shall not exceed +50℃ and not be lower than -10℃.

The altitude of the installation site shall not exceed 2000 meters

Humidity: no more than 60%

Pollution level 3


■ 主要技术参数 Main technical parameters

主要技术参数

额定电压:220VAC 50HZ

额定电流:1A-40A或1A-63A可调节(默认40A或63A)

过压动作切断值:240V-300VAC可调节(默认270VAC)

过压动作切断值:140V-200VAC可调节(默认170VAC)

过流动作切断值:63A:1A-63A可调节(默认63A)/40A:1A-40A可调节(默认40A)

通电及断电后送电延时时间:5-300S可调节(默认30S)

开机延时时间:1-300S可调节(默认5S)

过流保护后复位延时间:30-300S可调节(默认30S)

产品过流时间延时时间:6S(过流时间大于此时间将确认为过流并进行保护)

自身功耗:≤ 2W

电气机械寿命:≥10万次

外形尺寸:81×35×60mm

Main technical parameters

Rated voltage: 220VAC 50Hz

Rated current: 1A-40A or 1A-63A adjustable (default 40A or 63A)

Overvoltage action cut-off value: 240v-300vac adjustable (default 270vac)

Overvoltage action cut-off value: 140v-200vac adjustable (170vac by default)

Cut off value of overcurrent action: 63A: 1a-63a adjustable (default 63A) / 40A: 1a-40a adjustable (default 40a)

Power on and power off delay time: 5-300s, adjustable (default 30s)

Startup delay time: 1-300s, adjustable (default 5S)

Reset delay time after overcurrent protection: 30-300s adjustable (default 30s)

Product overcurrent time delay time: 6S (if the overcurrent time is greater than this time, it will be confirmed as overcurrent and protected)

Power consumption: ≤ 2W

Electrical and mechanical life: ≥ 100000 times

Overall dimension: 81×35×60mm

联系我们
总部:上海市奉贤区奉城镇工业园区
电话:021-57175508
乐清销售:柳市电器城A区292-293号
电话:0577-62755704
传真:0577-62733965 62817468